PROGRAMMING INSTRUCTIONS:
The washer has two levels of programming. The Washer Cycle Programming allows the owner complete
access to the wash cycle parameters – add/remove a bath, bath times, spin times, water temperatures, etc.
The Coin/Price Programming allows the owner to set the price for the washer features and the values of the
coins. To enter the programming modes, the top of the washer must be unlocked and slid toward the back
of the washer a few inches.
COIN PRICE PROGRAMMING:
While the washer is in the Idle mode, push the Programming pushbutton on the controller. The Idle mode is
when the washer is not running a cycle and the price of the bath is displayed. The Programming pushbut-
ton is a very small buttoned located on the upper center of the controller directly behind the display. There
are six stages in the Coin/Price Programming mode.
To step through to the desired stage, repeatedly push the right-hand Warm temperature button until the
desired stage is blinking on the display. To exit the Coin/Price programming mode, push and hold the Cold
temperature button for 5 seconds.
When manual programming mode is entered, the “Hot”, “(Left-Hand) Warm”, “(Right-Hand) Warm” and
“Cold” buttons perform alternate functions.
Right Coin – The display will blink rst an “r” indicating right coin and then a coin value (0.25 – default).
The display will blink back and forth between the “r” and the value. To change the value, use the Hot
temperature button to decrease and the left-hand Warm temperature button to increase. The value will
change in 5¢ steps. The range of values is from $00.00 to $99.95. When the desired right coin value is
displayed, push the right-hand Warm temperature button once to store the new value and a second time to
move to the next Coin/Price programming step. To exit the Coin/Price programming mode, push the Cold
temperature button for 5 seconds.
Left Coin – The display will blink rst a “L” indicating left coin and then a coin value ($1.00– default). The
display will blink back and forth between the “L” and the value. To change the value, use the Hot
temperature button to decrease and the left-hand Warm temperature button to increase. The value will
change in 5¢ steps. The range of values is from $00.00 to $99.95. When the desired left coin value is
displayed, push the right-hand Warm temperature button once to store the new value and a second time to
move to the next Coin/Price programming step. To exit the Coin/Price programming mode, push the Cold
temperature button for 5 seconds.
Wash Price – The display will blink rst a “P” indicating wash price and then present wash price. The
display will blink back and forth between the “P” and the price. To change the value, use the Hot
temperature button to decrease and the left-hand Warm temperature button to increase. The value will
change in 5¢ steps. The range of values is from $00.05 to $99.95. When the desired price is displayed,
push the right-hand Warm temperature button once to store the new value and a second time to move to
the next Coin/Price programming step. To exit the Coin/Price programming mode, push the Cold
temperature button for 5 seconds.
Button Name Alternate Function in Programming Mode
Hot Becomes the action to move DOWN through displayed options
Left-Hand
Warm
Becomes the action to move UP through displayed options
Right-Hand
Warm
Becomes the action to accept the displayed option or the “Enter” key
Cold Becomes the action to move back a step (1 press) or EXIT from
programming mode (press for 5 seconds)
33
Part # 8533-050-001 2/22
32
Part # 8533-050-001 2/22
Section 3:
Machine
Programming
Instructions
To Next Page
Loading...
Need help?
General
