DFI SB102-D - RJ45 LAN Ports; USB Ports

www.d.com
20
Chapter 2 Hardware Installation
Chapter 2
RJ45 LAN Ports
TheLANportsallowthesystemboardtoconnecttoalocalareanetworkbymeansofa
networkhub.
BIOS Setting
ConfiguretheonboardLANintheChipsetmenu(“SouthBridgeConfiguration”submenu)of
theBIOS.Refertochapter3formoreinformation.
Driver Installation
InstalltheLANdrivers.Refertochapter4formoreinformation.
LAN1
Features
• Intel82579LMGigabitEthernetPhy
• Intel82574LPCIExpressGigabitEthernetcontroller
LAN2
USB Ports
USBallowsdataexchangebetweenyourcomputerandawiderangeofsimultaneouslyacces-
sibleexternalPlugandPlayperipherals.
ThesystemboardisequippedwithfouronboardUSB2.0/1.1ports(USB0-1/8-9).Thetwo
10-pinconnectorsallowyoutoconnect4additionalUSB2.0/1.1ports(USB2-3/10-11).The
additionalUSBportsmaybemountedonacard-edgebracket.Installthecard-edgebracket
toanavailableslotattherearofthesystemchassisandtheninserttheUSBportcablestoa
connector.
BIOS Setting
ConfiguretheonboardUSBintheAdvancedmenu(“USBConfiguration”submenu)ofthe
BIOS.Refertochapter3formoreinformation.
Driver Installation
YoumayneedtoinstalltheproperdriversinyouroperatingsystemtousetheUSBdevice.
Refertoyouroperatingsystem’smanualordocumentationformoreinformation.
USB10-11
USB2-3
10
VCC
-Data
+Data
GND
Key
VCC
-Data
+Data
GND
N.C.
9
1
2
USB2.0
USB1
USB0
USB9
USB8
USB2.0