Note: Only 1 start time is available in hourly cyclical mode. The 710A will begin
hourly cyclical mode upon arriving at the set start time. The start time will then
update to show the next time the 710A will start defined by what hourly program
is set.
To delete a start time:
1. Push to select Start Time and push to enter adjustment mode.
2. Push or to advance the hours until the display shows OFF.
3. Push to confirm your settings and scroll through to review all start times
by pushing .
Push the button to proceed to the next step Run Time .
NOTE: In hourly cyclical mode, Run Time is limited to 59 minutes.
15. SETTING WATERING RUN TIMES
Note: If you have already set a SimpleSmart
™
ET preset (example: SP02) and then
change the run time, your SimpleSmart
™
program will be turned OFF. You must
reactivate the SimpleSmart
™
programming each time you adjust your run time
(see section 16).
This setting determines the length of time the 710A controller will allow the valve
to remain open (duration is from 1 minute up to 5:59 hours). For example, setting
watering run time to 10 minutes on certain days of the week will program the
controller to turn the water on for 10 minutes on each of the days chosen and at
every start time selected.
20
To Next Page
Loading...
Need help?
General
