28
20. MANUAL WATERING
The manual mode allows the user to test the system and water for a specified
run time. The controller will automatically close the valve at the end of the defined
irrigation period. The originally programmed irrigation schedules will continue to
function at the times assigned. The sensor condition and OFF mode is disregarded in
this mode.
To start a manual run,
1. Push the button, and the icon and icon appears. ON appears
momentarily and then the last watering run time is displayed with . The
controller will open the valve and in 3-5 seconds a count down of the remaining
irrigation run time appears, showing when the controller will close the valve.
The default run time is 5 minutes. Adjust to the desired manual run time length
by pushing .
2. Push the button to end manual run.
3. After 3-5 seconds the display will revert to the current time screen.
To Next Page
Loading...
