To Next Page

To Previous Page

11. PROGRAMMING

This section explains the programming features and the steps necessary to assign

irrigation schedules. To program the controller use the or buttons to select the

desired programming mode, then push to make the entry flash and the

buttons to change the value. Only a flashing value can be changed.

NOTE: If the last data entered stops flashing, push again to resume

programming and repeat the steps.

12. SETTING TIME AND DATE

The controller can display the time in either a 12 or 24 hour format.

To change the time format, from the current time:

1. Push and hold the button for three seconds until the display switches

format (AM/PM disappears).

SETTING THE CURRENT TIME AND DATE

To enable the controller to operate properly, the current time and date must

be set.

Questions and Answers:

Need help?

Do you have a question about the DIG 710A Series and is the answer not in the manual?

DIG 710A Series Specifications

General