Digi Connect ME

Network Interface
47
Module Specifications
APPENDIX A
Network Interface
Caution The Digi Connect ME and Digi Connect Wi-ME embedded modules were
designed for use in no clean flux wave soldering processes. The product is not
designed to support draining after a water-wash process, which can lead to water
residue inside the enclosure resulting from direct entry or condensation after the
wash process.
Digi Connect ME/ME 9210 Digi Connect Wi-ME
 Standard: IEEE 802.3
 Physical Layer: 10/100Base-T
 Data Rate: 10/100Mbps (auto-sensing)
 Mode: Half-duplex and full-duplex
support (auto-sensing)
 Connector: RJ-45
 Standard: IEEE 802.11b/Standard: IEEE 802.11b/g/n
 Frequency: 2.4 GHz
 Data Rate: Up to 11 Mbps with automatic fallback
 Modulation: CCK (11/5 Mbps), DQPSK (2 Mbps),
DBPSK (1 Mbps)
 Transmit Power: 16 dBm typical
 Receive sensitivity:
– 1Mbps: -92 dBm
– 2Mbps: -89 dBm
– 5.5Mbps: -87 dBm
– 11Mbps: -82 dBm
 Antenna Connector: 1 x RP-SMA