Digi XBee 3 User Manual

Transport Layer Security
(TLS)
Secure the connection between an XBee and Remote Manager with server
authentication
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
183
1. Cause an active connection to Remote Manager. For example, you could set bit 0 for the MO
command. Make sure that you do not clear bit 1.
2. After a short wait you should be able to see the device as connected in Remote Manager.
a. Log in to Remote Manager.
b. Click Device Management.
c. Locate the device in the device list and verify that the connection icon in the left column is
blue and the hover tool tip says "Connected".
3. When the device is connected to Remote Manager, the DIcommand can take on any of the
three values shown below, based on the security level of the connection. Verify the that the DI
command is set to 6 to verify that the server was correctly authenticated.
n 0: Connected without TLS
n 5: Connected with TLS but without authentication
n 6: Connected with TLS and with authentication

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English