Digi XBee 3 User Manual

Get started with Digi Remote Manager Configure Remote Manager features by scheduling tasks
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
55
1. Make sure that SM/UDPis enabled. See Enable SM/UDP.
2. Log into Remote Manager.
3. Click Device Management > Schedules.
4. Click New Schedule. The New Schedule page displays.
Note The Steps to schedule a task wizard may display. Click the x in the upper left corner to
close the wizard. See Schedule walk-through feature in the Digi Remote Manager® User Guide for
more information.
5. In the Description field, enter a name for the schedule, such "Read Settings."
6. Add the following tasks:
a. Click SM/UDP > SM/UDP Request Connect. A task is added to the dialog.
b. Add other tasks as needed. For examples, refer to the Examples section.
c. Click Device > Disconnect. A task is added to the dialog.
7. Click Schedule in the lower right corner of the dialog to schedule the tasks to run. The
schedule screen displays.
Note You can also click Save as to save this schedule for future use.
8. Select the device(s) on which you want to run this schedule. You can add more than one device.
9. Click Run Now.
Examples
The examples in the following sections assume you are using the Digi Remote Manager Schedule
wizard. However, you should be aware that operations can be created and performed
programmatically via web service calls or via the API explorer. The XML web service calls provide more
options than are available in the GUI dashboard for some tasks.
Example: Read settings and state using Remote Manager
In order to configure devices you will need to know the structure of the XML for your XBee's settings.
The easiest way to obtain this is to perform a query_setting RCI request against your device.
Note You must upgrade your device to the latest firmware for all features to be available. See Update
the firmware.
Note To obtain the state of the device, you can perform the same operations in the example below,
but replace query_setting with query_state.
1. Log into Remote Manager.
2. Click Device Management > Schedules.
3. Click New Schedule. The New Schedule page displays.
Note The Steps to schedule a task wizard may display. Click the x in the upper left corner to
close the wizard. See Schedule walk-through feature in the Digi Remote Manager® User Guide for
more information.

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English