Get started with Digi Remote Manager Remote Manager reference
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
64
8. Click the upload icon. The Upload File dialog appears.
a. Click Browse to browse for the file you want to upload. The selected file displays in the File
field. Make sure that the file name is appended by a hash sign (#).
b. Click OK. The uploaded file displays in the File Management view. Note that the file name
is no longer appended by a hash sign (#).
9. When all changes are complete, disconnect the device from Remote Manager.
Remote Manager reference
Enable SM/UDP
You can use the SM/UDP feature to leverage the very small data footprint of Remote Manager SM
protocol over UDP.
1. Log into Remote Manager.
2. Click Device Management > Devices.
3. Select the device that you want to configure.
4. Click More >SM/UDP > Configure. The SM/UDP dialog appears.
5. Verify that the Battery Operated Mode is not selected.
This mode is not supported with Remote Manager and if enabled, the connectivity between
XBee and Remote Manager may not work as expected.
6. Select SM/UDP Service Enabled to enable SM/UDP.
7. Click Save.
TCP connection
The TCP connection between an XBee and Remote Manager is dependent on the device's firmware
version. Options are to query Remote Manager once a day or to maintain a persistent TCP connection.
To determine which connection method is being used, refer to the version listed below.
Module Upgrade firmware version
XBee 3 CAT 1 31011
n At or above the listed version: If your firmware version is at or above the listed version, your
device queries Remote Manager only once a day. The device connects to Remote Manager,
queries Remote Manager for updates and then receives updates. When the update is complete,
the device disconnects from Remote Manager.
If you upgrade to the new firmware version, it is recommended that you keep the polling
frequency low to reduce data usage. In order to upgrade firmware in the future, refer to
Example: Schedule a task to update the device firmware using Remote Manager.
Note If you wish to restore the persistent connection behavior that was the default in prior
firmware versions, see Restore persistent connection to a remote XBee.
To Next Page
Loading...
Need help?
General
