Digi XBee 3

AT commands Cellular commands
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
187
Cellular commands
The following AT commands are cellular configuration and data commands.
PH (Phone Number)
Reads the SIM card phone number.
If PH is blank, the XBee Smart Modem is not registered to the network.
Parameter range
N/A
Default
Set by the cellular carrier via the SIM card
S# (ICCID)
Reads the Integrated Circuit Card Identifier (ICCID) of the inserted SIM.
Parameter range
N/A
Default
Set by the SIMcard
IM (IMEI)
Reads the device's International Mobile Equipment Identity (IMEI).
Parameter range
N/A
Default
Set in the factory
II (Subscriber identity)
Reads the IMSI (International Mobile Subscriber Identity) from the SIM inserted into the module.
Parameter range
N/A
Default
N/A
MN (Operator)
Reads the network operator on which the device is registered.
Parameter range
N/A