Digi XBee 3 User Manual

Regulatory information Labeling requirements for the host device
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
292
2.5 Trace antenna designs
While it is possible to build a trace antenna into the host PCB, this requires at least a Class II
permissive change to the FCC grant which includes significant extra testing and cost. If an embedded
trace or chip antenna is desired contact a Digi sales representative for information on how to engage
with a lab to get the modified FCC grant.
2.6 RF exposure considerations
For RF exposure considerations see RF exposure.
Host product manufacturers need to provide end-users a copy of the “RF Exposure” section of the
manual: RF exposure.
2.7 Antennas
A list of approved antennas is provided for the XBee Smart Modem. See Cellular antennas.
2.8 Label and compliance information
Host product manufacturers need to follow the sticker guidelines outlined in Labeling requirements
for the host device .
2.9 Information on test modes and additional testing requirements
Contact a sales representative for information on how to configure test modes for the XBee Smart
Modem.
2.10 Additional testing, Part 15 Subpart B disclaimer
All final host products must be tested to be compliant to FCC Part 15 Subpart B standards. While the
XBee Smart Modem was tested to be complaint to FCC unintentional radiator standards, FCC Part 15
Subpart B compliance testing is still required for the final host product. This testing is required for all
end products, and XBee Smart Modem Part 15 Subpart B compliance does not affirm the end
product’s compliance.
See FCC notices.
Labeling requirements for the host device
The device shall be properly labeled to identify the product within the host device. For more
information, see the Regulatory Approvals table.
The certification labels of the module shall be clearly visible at all times when installed in the host
device, otherwise the host device must be labeled to display the FCC ID and IC of the module,
preceded by the words "Contains transmitter module", or the word "Contains", or similar wording
expressing the same meaning, as follows:
Contains FCC ID: MCQ-XB3C1
Contains IC: 1846A-XB3C1
Contains FCC ID:RI7XE866A1NA
Contains IC: 5131A-XE866A1NA
L'appareil hôte doit être étiqueté comme il faut pour permettre l'identification des modules qui s'y
trouvent. Pour plus d'informations, reportez-vous au tableau des approbations réglementaires.
L'étiquettes de certification du module donné doit être posée sur l'appareil hôte à un endroit bien en vue en
tout temps. En l'absence d'étiquette, l'appareil hôte doit porter une étiquette donnant le FCC ID et le IC du

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English