AT commands Diagnostic interface commands
Digi XBee® 3 Cellular LTE Cat 1 AT&T Smart Modem User Guide
226
Parameter range
0-1
Value Description
0 or no value
Scans for mobile cells in the vicinity and returns information about the cells
in the service area of the module. When you run the command, the cell
module waits until all other communication is idle and then performs the
scan.
1
Attempts a full scan, which requires dropping network registration. Any
outstanding sockets or other activity will be lost. Since registration is lost,
no "serving cell" information is provided, as the "serving cell" that the
device will re-join cannot be reported, and there is no guarantee that the
"serving cell" the device was on before network registration was dropped
will still be used.
A full scan can return more complete information for all cells seen, which
includes cells offered by other carriers.
The duration of the scan is approximately 25 seconds.
Note This action should be used only on CAT 1 modules. If this value is set
on an LTE-M module, the result will be as if the value was set to 0.
Parameter range
N/A
Default
N/A
To Next Page
Loading...
Need help?
General
