AT commands Network commands
Digi XBee3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
168
Note Setting P0 (DIO10/PWM0 Configuration) to 6 overrides setting DO bit 2.
Bit 3 - PSM
To enable PSM, set DO (Device Options) bit 3. See Power Saving Mode (PSM) for details.
Range
0x00 - 0x0F
Bitfield
Bit Description
0x00 Enable Remote Manager
0x02 Enable USB Direct
0x03 Enable PSM
Note We strongly recommend that you clearbit 0 (Enable Remote Manager) if you set bit 3. If not, the
connection that the device retains with Remote Manager causes the cellular component to spend very
little time in low power, negating the value of selecting that feature.
Default
0x01 (Bit 0 enabled)
DT (Cellular Network Time)
Reads the current network-provided local time of the XBee device.
If the time is not known, the response is empty.This value is synchronized with the network
approximately once per hour.
Parameter range
0 - 1
Value Description
0 The response is the number of seconds since 2000-01-01 00:00:00 UTC, as a
32-bit number. This is the default.
1 The response is the current date and time in ISO 8601 format. For example,
"2018-12-25T22:00:05".
Note You can also send DT, which acts like DT=0.
Default
0
To Next Page
Loading...
Need help?
General
