Digi XBee3 XB3M1

AT commands BLE commands
Digi XBee3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
201
$V, $W, $X, $Y (SRPpassword verifier)
Note You should only use these commands if you have already configured a password on the XBee
device and the salt verifier values correspond to the password.
The $V, $W, $X, and $Y commands are used in conjunction with the $S command used to create an
encrypted password for the XBee device. Together with the $S command, these commands
authenticate the client for the BLE API Service without storing the XBee password on the XBee device.
The salt is configured in the $S command. In the $V, $W, $X, and $Y verifiers, you specify the 128-byte
verifier value, where each command represents 32 bytes of the total 128-byte verifier valule.
Parameter range
1 - 32 bytes (1-64 hexadecimal characters in command mode)
Default
0