Digi XBee3 XB3M1

AT commands Firmware version/information commands
Digi XBee3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
192
Statuscode Meaning
0x25 Cellular network registration denied.
0x2A Airplane mode.
0x2B USB Direct active.
0x2C
Cellular component is in PSM.
Note For NB-IoT, TCP support is dependent on the network. Contact your network
provider for details.
0x2F Bypass mode active.
0xFF Initializing.
Parameter range
0 - 0xFF [read-only]
Default
N/A
HS (Hardware Series)
Read the device's hardware series number.
Parameter range
N/A
Default
Set in the firmware
CK (Configuration CRC)
Displays the cyclic redundancy check (CRC) of the current AT command configuration settings.
Parameter range
0 - 0xFFFFFFFF
Default
N/A