To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
Need help?Do you have a question about the Digi XBee3 XB3M1 and is the answer not in the manual?
Information on how to contact Digi for technical assistance, including phone and website.
Provides step-by-step instructions for connecting the XBee Smart Modem and antennas to the development board.
Guides on using XCTU to update the XBee module to the latest firmware version.
Instructions on setting up the module for cellular connectivity and configuring the APN.
Steps to verify proper cellular network registration and IP address assignment using AT commands.
Instructions for updating the u-blox cellular module using ATMV, API mode, or FOTA.
Provides instructions for connecting to any TCP/IP server using Transparent mode.
Explains the MQ Telemetry Transport (MQTT) protocol and its use with XBee devices.
Guides on entering the MicroPython environment and using the MicroPython Terminal in XCTU.
Explains how to enable and configure Bluetooth Low Energy (BLE) on XBee devices.
Instructions on connecting to XBee devices via BLE and configuring them using the mobile app.
Steps to create a Digi Remote Manager account and add XBee devices to the inventory.
Explains how to configure device settings and schedule tasks for remote management.
Guides on updating XBee firmware remotely using Digi Remote Manager.
Details the physical and interface specifications of the XBee Smart Modem.
Specifies the voltage and current requirements for operating the XBee Smart Modem.
Details the current draw of the XBee Smart Modem in various operating states.
Lists the electrical parameters such as voltage, current, and timing for the XBee Smart Modem.
Shows the physical dimensions and pin layout of the XBee Smart Modem.
Details the function and assignment of each pin on the XBee Smart Modem.
Offers suggestions for optimal antenna placement to ensure performance and avoid interference.
Stresses the importance of providing access for cellular component firmware updates via USB.
Provides design practices for ensuring a stable and adequate power supply for the XBee Smart Modem.
Details methods for safely shutting down the XBee modem to prevent data corruption.
Describes the sequence of steps the XBee Smart Modem takes to establish a cellular and data network connection.
Explains how communication with remote servers is initiated after establishing a data network connection.
Introduces the different operating modes (Transparent, API, Bypass) and how to select them using the AP command.
Explains API mode for structured, packet-based communication via serial or SPI.
Details how to enter and use Command mode to configure the device using AT commands.
Covers accessing and using the MicroPython environment on the XBee Smart Modem.
Details enabling PSM via DO bit 3 for low-power operation, with network-dependent support.
Covers Deep Sleep mode where the cellular component is shut off and the processor sleeps.
Lists AT commands used for interacting with TLS features like file system and protocol versions.
Guides on securing TLS connections to Digi Remote Manager with server authentication.
Details AT commands for cellular configuration, such as PH, S#, IM, MN, MV, DB, AN, CP, BM, BN, AM, N#.
Covers AT commands related to network settings like IP, TL, $, TM, TS, and DO.
Explains AT commands for configuring Remote Manager interaction, such as DF, EQ, K1, K2, MO, $D, RI, DP, HF, HM.
General
