Digi XBee3 XB3M1 User Manual

Get started with the XBee Smart Modem Development Kit Configure and update your XBee
Digi XBee3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
32
UScustomers
Note Some carriers require an APN. If the carrier does not require an APN, you should not change the
APN from the default
1.
Click the Configuration working modes button
2. Select an XBee module from the Radio Modules list.
3. Set the APN using the AN command. You should get the APN from your carrier when you
purchased your SIMcard. See Acquire a SIM card.
4. To set the APN, in the AN field, type the APN value from your carrier and click the Write button
.
European customers
Note Some carriers require an APN. If the carrier does not require an APN, you should not change the
APN from the default
1.
Click the Configuration working modes button .
2. Select an XBee module from the Radio Modules list.
3. Set the APN using the AN command. You should get the APN from your carrier when you
purchased your SIMcard. See Acquire a SIM card.
To set the APN, in the AN field, type the APN value from your carrier and click the Write button
.
4. Set the N# parameter to 3. In the N# field, select NB-IoT Only [3] and click the Write button
.
5. Enable the bands. The bands are specified as a bit mask given as a hexadecimal value.
To enable bands 8 and 20, in the BNfield, enter 80080 and click the Write button .
6.
To set the CP, in the CP field, select No Profile (1) and click the Write button .
7. Reset the module with either the reset button or issue the FR command.

Digi XBee3 XB3M1 Specifications

General

Brand	Digi
Model	XBee3 XB3M1
Category	Modem
Language	English