Appendix C: Utility Mode (003 Only) 113
appendix c
Utility Mode (003 Only)
003 is in this mode when the Utility switch is
enabled (flashing). In Utility mode, you can run
pre-programmed diagnostic tests of the 003
unit. The Utility switch is unavailable in
Pro Tools mode.
Utility functions include the following:
• Software and firmware version display
• Tests for the LCD display, LEDs, switches,
rotary encoders, faders, MIDI, and audio.
• Return MIDI Maps to factory default set-
tings. See the 003 MIDI Mode Guide.
Accessing Utility Mode
To enter Utility mode:
1 If Pro Tools is running, choose File > Exit
(Windows) or Pro Tools > Quit (Mac).
2 Press the Utility switch.
The Utility switch flashes when it is enabled.
The LCD shows the top level Utility functions
across the lower row: Version and Test. The cor-
responding Channel View switches flash for
each available Utility option.
Navigating Utility Mode
When running a Utility mode test, you can re-
turn to the previous Utility page or exit the test
at anytime.
To return to the previous Utility page:
Press the flashing Display Mode switch.
To exit a test:
Press the flashing ESC switch or Display Mode
switch.
Exiting Utility Mode
To exit Utility mode:
1 If a test is running, press ESC or Display Mode
to exit the test.
2 Press the flashing Utility mode switch.
Utility mode is not available in Pro Tools
mode. Pro Tools must be closed to enable
Utility mode.
To Next Page
Loading...
Need help?
General
