Chapter 6: 003 Top Panel 35
Display Mode Switch
This switch is used to change default LCD dis-
plays:
• Full names of items with more than 6 charac-
ters can be temporarily displayed in the LCD.
See “Displaying Full Names of Tracks, Insert
Parameters, and Other Elements” on page 90.
• The lower row of the LCD shows track or con-
trol names by default. The display can be
changed to temporarily show settings by
pressing and holding the Display Mode
switch, or be reset to always show settings. See
“Displaying Settings Instead of Track or Con-
trol Names” on page 90.
The Display Mode switch flashes during a tem-
porary display or when the LCD default has
been reset to always show settings.
Host (“1394”) Status Indicator
The Host status LED, marked “1394” below its
LED, indicates that communication has been es-
tablished between the unit and Pro Tools LE
software (or another software application)
through FireWire.
Sync Indicators
The Sync LEDs indicate the current clock source.
When the current clock source is not estab-
lished, the respective LED flashes.
If none of the Sync LEDs are lit, 003’s clock
source is set to internal.
There are three Sync LEDs:
W Clk (Word Clock) LED Lights when clocking
to Word Clock.
S/PDIF LED Lights when clocking to the S/PDIF
on the RCA or Optical port.
ADAT LED Lights when clocking to ADAT on the
Optical port.
MIDI Data Indicators
The MIDI Data LEDs indicate the presence of
MIDI data on the MIDI In, MIDI Out 1, or MIDI
Out 2 ports. Individual LEDs are provided for
each port. Active sensing is not indicated.
To Next Page
Loading...
Need help?
General
