DIGITAL-LOGIC Microspace MSM586SEN - Error Beep Codes

DIGITAL-LOGIC AG MSM586SEN/SEV Manual V1.5E
112
29H DEBUG_RAM_SIZE_DONE RAM test completed
2AH DEBUG_RAM_PROT_EXIT Protected mode exit successful
2BH DEBUG_CS_SHADOW_SETUP Setup Shadow
2CH DEBUG_VIDEO_EQUIP_INIT_INIT Going To Initialize Video
2DH DEBUG_VIDEO_BW_SEARCH Search For Monochrome Adapter
2EH DEBUG_VIDEO_COLOR_SEARCH Search For Color Adapter
2FH DEBUG_VIDEO_SIGNON Signon messages displayed
30H DEBUG_OEM_CONFIG_KBD_CTL special init of keyboard ctlr
31H DEBUG_KEYB_PRESENT_TEST Test If Keyboard Present
32H DEBUG_KEYB_TEST_IRQ1 Test Keyboard Interrupt
33H DEBUG_KEYB_TEST_CMD Test Keyboard Command Byte
34H DEBUG_RAM_FULL_TEST TEST, Blank and count all RAM
35H DEBUG_RAM_PROT_ENTRY_2 Protected mode entered safely (2).
36H DEBUG_RAM_TEST_DONE RAM test complete
37H DEBUG_RAM_PROT_EXIT_2 Protected mode exit successful
38H DEBUG_KEYB_OUTPUT_PORT Update OUTPUT port
39H DEBUG_CS_CACHE_SETUP Setup Cache Controller
3AH DEBUG_HWIO_TEST_PERIODIC Test If 18.2Hz Periodic Working
3BH DEBUG_GEN_CHECK_RTC test for RTC ticking
3CH DEBUG_GEN_INIT_HARD_VECS initialize the hardware vectors
3DH DEBUG_MOUSE_INIT Search and Init the Mouse
3EH DEBUG_KEYB_SET_LEDS_1 Update NUMLOCK status
3FH DEBUG_OEM_DEVICE_CONFIG special init of COMM and LPT ports
40H DEBUG_CS_CONFIG_PORTS Configure the COMM and LPT ports
41H DEBUG_FLOP_INIT Initialize the floppies
42H DEBUG_WINI_INIT Initialize the hard disk
43H DEBUG_HWIO_ROM_INIT Initialize option ROMs
44H DEBUG_OEM_INIT_POWER_MAN OEM's init of power management
45H DEBUG_KEYB_SET_LEDS_2 Update NUMLOCK status
46H DEBUG_HWIO_FIND_80X87 Test For Coprocessor Installed
47H DEBUG_OEM_LAST_MINUTE_INIT OEM functions before boot
48H DEBUG_MISC_LAUNCH_INT19 Dispatch To Op. Sys. Boot
49H DEBUG_BEGIN_BOOT_CODE Jump Into Bootstrap Code
17.2.4 Error Beep codes
S-S-S-P-S-S-L-P The DMA page registers are faulty.
S-S-S-P-S-L-S-P The refresh circuitry is faulty.
S-S-S-P-S-L-L-P The ROM checksum is incorrect.
S-S-S-P-L-S-S-P The CMOS RAM test failed.
S-S-S-P-L-S-L-P The DMA controller is faulty.
S-S-S-P-L-L-S-P The interrupt controller failed.
S-S-S-P-L-L-L-P The 8042 keyboard controller failed.
S-S-L-P-S-S-S-P No video adapter was found.
S-S-L-P-S-S-L-P No RAM is installed. No message is displayed.
S=Short, L=Long, P=Pause