DLP Projector—User’s Manual
— 8 —
ITEM LABEL DESCRIPTION SEE PAGE:
1.
Power OFF Turns the projector off
13
2.
DVI Displays the DVI source selection
3.
VGA Displays the VGA source selection
4.
DP Displays the DisplayPort source selection
5.
Up cursor /
Keystone+
Navigates and changes settings in the OSD
Quick Menu – For Keystone
6.
ENTER Enters and confirms settings in the OSD
7.
Right cursor Navigates and changes settings in the OSD
8.
Down cursor /
Keystone-
Navigates and changes settings in the OSD
Quick Menu – For Keystone
22
9.
3D Activate 3D video
10.
PICTURE MODE Changes the Display Mode setting
11.
SOURCE Alternate input source
22
12.
CONTRAST Displays the contrast settings bar
13.
BRIGHT Displays the brightness setting bar
14.
SHARP Displays the sharpness setting bar
15.
COLOR Displays the color setting bar
16.
FREEZE Freezes/unfreezes the on-screen picture
17.
VOL + Adjusts volume
18.
AUTO Auto adjustment for frequency, phase, and position
19.
VOL - Adjusts volume
22
20.
BLANK Makes the screen blank
21.
TINT Displays the tint setting bar
22.
MUTE Mutes the built-in speaker
23.
STATUS
Opens the OSD Status menu (the menu only opens when an input
device is detected)
24.
ASPECT RATIO Displays the ASPECT RATIO selections
25.
MENU
Opens
or closed the OSD
22
26.
Left cursor Navigates and changes settings in the OSD
22
27.
COMP Displays the Component source selection
28.
VIDEO Displays the VIDEO source selection
29.
HDMI 1 Displays the HDMI 1 source selection
30.
Power ON Turns the projector on
13
31.
Status LED Lights when the remote control is used
32.
IR transmitter Transmits signals to projector
33.
Wired remote
connector
Wired remote function
used
To Next Page
Loading...
Need help?
General
