Digital Projection E-Vision Series - Settings 2 Menu

DLP Projector—User’s Manual
Settings 2 Menu
Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the
Settings 2 menu. Press the cursor ▲▼ button to move up and down in the Settings 2 menu.
ITEM DESCRIPTION
Auto Source
Press the cursor ◄► button to enter and enable or disable automatic source
detection.
No Singal Power
Off (min.)
Press the cursor ◄► button to enter and enable or disable automatic shutdown of
lamp when no signal.
Auto Power On
Press the cursor ◄► button to enter and enable or disable automatic power On when
AC power is supplied.
Lamp Mode
Press the cursor ◄► button to enter and select the lamp mode for higher brightness
or lower brightness to save lamp life.
Reset All Press (Enter) / ► to reset all settings to default values.
Status
Press
(Enter) / ► to enter the Status menu. See page 35 for more information on
Status.
Advanced 1
Press
(Enter) / ► to enter the Advanced 1 menu. See Advanced 1 Feature on
page 36.
Advanced 2
Press
(Enter) / ► to enter the Advanced 2 menu. See Advanced 2 Feature on
page 48.
— 34 —