Digital Projection E-Vision Series - Advanced 1 Feature

DLP Projector—User’s Manual
Advanced 1 Feature
Press the Menu button to open the OSD menu. Press ◄► to move to the Settings 2 menu.
Press ▲▼ to move to the Advanced 1 menu and then press Enter or ►. Press ▲▼ to move up
and down in the Advanced 1 menu. Press ◄► to
enter and change values for setting.
ITEM DESCRIPTION
Menu Position Press the cursor ◄► button to enter and select different OSD location.
Translucent Menu Press the cursor ◄► button to enter and select OSD background translucent level.
Low Power Mode Press the cursor ◄► button to enter and turn Low Power Mode on or off.
Fan Speed
Press the cursor ◄► button to enter and toggle between Normal and High fan speeds.
Note: We recommend selecting high speed in high temperatures, high humidity, or
high altitude (higher than 1500m/4921ft) areas.
Lamp Hour Reset
After replacing the lamp, this item should be reset. See page 37 for more information
on Lamp Hour Reset.
Projector ID
Press the cursor ◄► button to enter and adjust a two digit projector ID from 00
through 98.
Network
Press
(Enter) / ► to enter the Network menu. See page 37 for more information on
Network.
Projection Angle
Caution
Press the cursor ◄► button to enter and turn Projection Angle Caution on or off.
— 36 —