EasyManuals Logo

Digital Projection E-Vision Series User Manual

Digital Projection E-Vision Series
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
P
P
P
r
r
r
e
e
e
f
f
f
a
a
a
c
c
c
e
e
e
Power Safety
Only use the supplied power cord.
Do not place anything on the power cord. Place the power cord where it will not be in the way of
foot traffic.
Remove the batteries from the remote control when storing or not in use for a prolonged period.
Replacing the Lamp
Replacing the lamp can be hazardous if done incorrectly. See Replacing the Projection Lamp on page 52
for clear and safe instructions for this procedure. Before replacing the lamp:
Unplug the power cord.
Allow the lamp to cool for about one hour.
Caution:
In rare cases the lamp bulb may burn out during normal operation and cause glass dust or shards
to be discharged outward from the rear exhaust vent.
Do not inhale or do not touch glass dust or shards. Doing so could result in injury.
Always keep your face away from the exhaust vent so that you do not suffer from the gas and
broken shards of the lamp.
Cleaning the Projector
Unplug the power cord before cleaning. See Cleaning the Projector on page 58.
Allow the lamp to cool for about one hour.
Regulatory Warnings
Before installing and using the projector, read the regulatory notices in the Regulatory Compliance on
page 71.
Important Recycle Instructions:
Lamp(s) inside this product contain mercury. This product may contain other electronic waste that
can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal
Laws. For more information, contact the Electronic Industries Alliance at WWW.EIAE.ORG
. For lamp
specific disposal information check WWW.LAMPRECYCLE.ORG.
Symbol Explanations
DISPOSAL: Do not use household or municipal waste collection services for
disposal of electrical and electronic equipment. EU countries require the use
of separate recycling collection services.
v

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digital Projection E-Vision Series and is the answer not in the manual?

Digital Projection E-Vision Series Specifications

General IconGeneral
DimensionsVaries by model
TechnologyDLP
Light SourceLaser
Light Source LifeUp to 30, 000 hours (laser)
Throw RatioVaries by model
Projection SizeVaries depending on lens and distance
Input LagVaries by model
Color GamutVaries by model, typically Rec.709
HDR SupportYes
3D SupportYes
Lens ShiftVertical and Horizontal
Keystone CorrectionYes
InputsHDMI, DisplayPort, DVI, VGA
WeightVaries by model (typically 20-50 lbs)
Power ConsumptionVaries by model (typically 300-500W)

Related product manuals