Setting up Pro Tracks Plus
™
for GNX4 Audio
1. From the Pro Tracks Plus menu bar,select Options>Audio. The Audio Options window will
appear. Click the Drivers tab.
2. Under the Input Drivers settings,select DigiTech USB 1-2 In/Out and DigiTech USB 3-4 In
Only and deselect all other options.
3. Under the Output Drivers settings,select DigiTech USB 1-2 In/Out and deselect all other
options.
4. Click the OK button.
5. Click the OK button when the window stating changes will be saved upon re-start appears.
6. Close the Pro Tracks Plus application. When you are prompted to save changed,click No.
7. Re-start the Pro Tracks Plus application again.
8. Close the Tip of the Day and Quick Start windows if they appear.
9. From the Pro Tracks Plus menu bar, select Options>Audio.
10. Verify that the Playback and Record Timing Master settings have DigiTech USB 1-2 In/Out select-
ed. If not, select these now.
11. Click the Wave Profiler button at the bottom.
12. Click the Ye s button to continue performing the tests.
13. When the profiling operation is successfully completed, click the OK button.
14. Click the OK button to close the Audio Options window if it is still open.
You are now ready to use the GNX4 with Pro Tracks Plus recording software.
CAUTION: Do not disconnect power or disconnect the USB cable from the GNX4 or the
computer while the Pro Tracks Plus software is running. Doing so can result in unpre-
dictable behavior from your computer’s operating system.
94
Computer Recording via USB
To Next Page
Loading...
Need help?
General
