Type - Knob 1 is used to select one of the 5 Talker types. Talker types range from talker 1 (deep
tonal characteristics),to
talker 5 (bright tonal characteristics).
Sensitivity - Knob 2 adjusts the sensitivity of the microphone level (
MIC LEVL). The input level
from your microphone must be loud enough for the Talker to work properly. If the microphone input
is too weak,the Talker will have trouble tracking. If the input is too strong,the Talker will clip making
the words unintelligible. Adjust the mic level on the GNX4’s rear panel so that the LEDs light,but
stay below the the clip level. (See Optimizing the Mic Input Level on page 13 for more
information regarding mic level adjustment.) The mic level sensitivity ranges are from
0 (least
sensitive) to
99 (most sensitive).
Knob 3,Knob 4, and Knob 5 have no function when Talker is selected.
Stomp Box Modeling
The GNX4 Stomp Box Modeling emulates the tones of the most popular distortion boxes ever used
including the DOD OD250,Boss DS-1,Arbiter Fuzz Face,Electro Harmonix Big Muff,ProCo RAT, DOD
Grunge, Boss Metal Zone,Ibanez TS-9,Voodoo Labs Sparkle Drive, and the Guyatone OD-2*.
*Arbiter, Boss,Electro-Harmonix,ProCo,Ibanez,Voodoo Labs, Guyatone,DS-1, Fuzz Face,Big Muff,RAT,Metal Zone,TS-9, Sparkle Drive,and
OD-2 are trademarks of their respective companies and are in no way associated with DigiTech
Stomp Box On/Off -The Status button turns the Stomp Box Modeling on and off.
Type - Knob 1 selects the type of Stomp Box to be used.Choices include:
Screamer Based on an Ibanez TS-9 Guy OD Based on a GuyaTone OD-2
RODENT Based on a ProCo Rat Distortion SpArkDrv Based on a Voodoo Labs SparkleDrive
DS Dist Based on a Boss DS-1 Grunge Based on a DigiTech
®
Grunge
®
DOD 250 Based on a DOD Overdrive 250 Fuzzy Based on an Arbiter Fuzz Face
BIG MP Based on the Electro Harmonix Zone Based on a Boss Metal Zone
Big Muff Pi
Type Gain Param1 Param2 Param3* Param4* Level
Screamer drive tone level
Rodent dist filter volume
DS Dist dist tone level
DOD 250 gain level
Big MP sustain tone volume
Guy OD drive level
Sparkdrv gain tone clean volume
Grunge grnggain butt face loud
Fuzzy fuzz volume
Zone dist mid freq mid lvl low high level
Gain - Knob 2 controls the amount of Gain or distortion in the Stomp Box model. Range is from 0 to
99.
Parameter 1 - Knob 3 acts as a Tone control for each Stomp Box and controls the Mid Frequency of
the Zone model. Range is from
0 to 99.
Parameter 2 - Knob 4 acts as a second Tone control for the SparkleDrive,and Grunge Stomp Box
models and controls the Mid Level of the Zone model. Range is from
0 to 99.
*Parameter 3 - Controls the Low Frequency of the Zone model. Range is from
0 to 99.
*Parameter 4 - Controls the High Level of the Zone model. Range is from
0 to 99.
Level - Knob 5 controls the output level of the Stompbox model. Range is from
0 to 99.
*These Parameters are only available using the X-E
DIT
™
Editor/Librarian software.
38
Effects and Parameters
To Next Page
Loading...
Need help?
General
