Viewing/Editing Effect Parameter Values
To view or edit an effect parameter’s current value,you must first select the row in which the desired
parameter resides by using the Effect Select Buttons. They are located to the left of the Status
Button. After selecting the desired effect, use the Status Button and Knobs to adjust the effect’s
individual parameters. Parameter adjustments will show in the displays as edits are made. To exit effect
editing,press the EXIT button in the Control Panel.
NOTE: If a parameter name is shown in the display while editing both Amps and Effects,the
DATA WHEEL can change the value as well as the Knobs.
To Next Page
Loading...
