1.Press the SONG SETUP button until the GNX4’s main display reads drum lvl.
2.Use the DATA WHEEL to adjust the output level of a Drum Pattern or MP3 file.
3.When finished, press EXIT.
Song Tempo
The Song Tempo setup sets the tempo used by the recorder’s Click Track and the GNX4’s drum machine
during the recording and playback of a song. This tempo should be set before any audio is recorded if the
Click Track or drum machine is to be used as a metronome during recording. When the DRUMS/MP3
button is enabled in the Recorder Panel and the PLAY button is pressed on the recorder, this setting will
override the DRUMS/MP3 Tempo button located in the far right Control Panel. The Song Tempo function
has no control when an MP3 file is selected using the Drums-MP3 (Pattern/File) setup. To set the Song
Tempo,follow these steps:
Begin with the recorder stopped.
1.Press the SONG SETUP button until the GNX4’s main display shows the tempo’s numeric value
measured in beats per minute.For example, 124 beats per minute will display as 124 BPm.
2.Use the DATA WHEEL to adjust the tempo.
3.When finished, press EXIT.
NOTE: Although the Tempo of a song can be changed after tracks have been recorded, it is
not recommended because previously recorded tracks will not be synchronized with
the tracks recorded after the change. The Recorder Tempo also controls the Drum
Machine tempo when recording or playing a virtual Drum track.
1. Press the Song
2. Use the Data Wheel to
3. When finished
To Next Page
Loading...
Need help?
General
