edit row selected,the Status button turns Channel Two’s EQ on and off. With the TONE (Silver) edit row
selected,the Status button selects between Channel One Amp,Warped Amp,and Channel Two Amp. The
Amp Gain,Bass, Midrange,Treble, and Amp Levels alternate between editing Channel One’s (lit green) or
Channel Two’s (lit red) amp settings as the status button is pressed. When editing effects in the Effect
Matrix,the Status Button turns the selected effect on and off,or selects a controller type for the
expression assignment.
7. Knobs
Depending on which amp control row or effect row is selected using the Amp Control or Effect
Select buttons,these 5 knobs adjust the parameters listed in the column directly above or below each
knob.
8. Matrix
a. GeNetX
™
Amp Controls Matrix
The GeNetX Amp Controls Matrix displays the GNX4’s Channel One and Channel Two amp types,
cabinet types,EQ/tone controls,and cabinet tuning parameters available for editing in each preset.
b.Effects Matrix
The Effects Matrix displays the effects parameters available for editing in each preset.
9. Displays
The Displays give feedback of the various functions that are being used in the GNX4,including preset
name, editing functions,tuner, utility menus, drum machine and recorder settings.
10. Preset Bank LEDs
The Preset Bank LEDs indicate whether the selected preset is an internal Factory or User preset,or if
the preset is a user preset saved externally on the optional Compact Flash memory card.
11. Data Wheel
The Data Wheel is a multi-function control used for selecting presets,editing preset parameters or for
adjusting the settings of the Recorder, Drum Machine, Utility, and Output Setup menus.
12. Status Indicator LEDs (+48V,V-Switch, and USB Active)
The Status Indicator LEDs illuminate when the Microphone Input has +48V Phantom Power active,the
Expression Pedal’s V-Switch is engaged, or the USB connection is active.
13. Control Panel Buttons
The Control Panel Buttons are used to select the GNX4’s Footswitch Modes,Output Setups,Utility
functions,and to store Amp/Cabinet Model edits and Preset changes. They also access the GNX4’s
onboard General MIDI Drum Machine and MP3 Player. The buttons are labeled as follows:
MODE - This button changes the functionality of footswitches 1-5 (see the Footswitch Functions
for Modes section on page 59). When the Mode button is lit yellow, footswitches 1-5
toggle effects on and off,change amp channels,or can be assigned to various parameters
using the control footswitches. When the Mode button is lit green,footswitches 1-5 select
presets in the current preset bank. When the Mode button is lit red,footswitches 1-5
control the GNX4’s recorder functions.
4
Introduction
To Next Page
Loading...
Need help?
General
