28
The JamMan
®
Delay’s delay settings can be stored to any of the numbered
footswitches allowing instant recall of these settings during performance. When
delay settings are modified by turning the knobs, the DELAY STORE button will
light. To store modified settings to the footswitches, follow these steps:
Press the 1. DELAY STORE button. This button will now be lit and the DELAY
FOOTSWITCHES
will begin flashing.
Press any flashing 2. DELAY FOOTSWITCH to store the settings to that
footswitch (or press the DELAY STORE button again to store the settings
to the currently active DELAY FOOTSWITCH).
The 3. DELAY STORE button will turn off and the active footswitch will
stop flashing and light solid to indicate the new settings have now been
stored to this location.
To recall stored delay settings, press the DELAY FOOTSWITCH they were stored to.
You can also store delay settings during live performance (such as a new
tapped tempo) by pressing and holding the active delay memory footswitch
for 3 seconds.
NOTE: Delay settings cannot be edited or stored when the delay effect is
bypassed.
Storing and Recalling Delay Settings
To Next Page
Loading...
Need help?
General
