50
Before you begin recording a phrase, you may want to set a tempo at which
you want to record the loop at. Setting the tempo in an empty loop memory
location automatically starts playing the rhythm guide track (Rhythm Level
must be turned up to hear the guide track). You can use the rhythm guide
track as a metronome for recording against to help keep a consistent tempo
of your performance. To set the tempo for recording, follow these steps:
Use the 1. SELECT buttons to select a new memory location. (The LOOP
LED and SINGLE LED will be off.)
Tap the 2. TEMPO/STOP footswitch at least 2 times (4 or more times is
recommended). The TEMPO/STOP footswitch LED will begin flashing
at the tempo that has been tapped in. The first downbeat of the
measure flashes red and the other beats flash green.
Turn up the 3. RHYTHM LEVEL knob (if it hasn’t been already) to hear the
rhythm guide track.
To begin recording, press the 4. REC/PLAY/OVERDUB footswitch, wait for
the one-measure count-in and begin playing.
If you want to set up a memory location with a tempo but not record to it, you
can just follow steps 1 and 2, but you must then store the new tempo using the
Store procedure. When you return to the empty loop location, the tempo will
already be set as indicated by the TEMPO/STOP footswitch LED flashing.
Setting a Loop Tempo for Recording
To Next Page
Loading...
Need help?
General
