66
The Erase Loops procedure only erases JamMan
®
Delay loop data from a
memory card. All other data and files on the card are left untouched.
To erase all loops from an optional SD/SDHC memory card, follow these steps:
Install an optional SD/SDHC memory card in the JamMan Delay’s 1.
memory card slot.
Select a loop memory location that lights the 2. CARD MEM LED.
Press and hold the 3. LOOP STORE button for four seconds until EC
(Erase Card Memory Loops) appears in the DISPLAY and release (EL
will show briefly first but keep holding the button). The LOOP STORE
button will now be flashing.
Press the 4. LOOP STORE button again. The DISPLAY will now read E?
(Erase Loops?) and the button will continue to flash. To abort this
procedure, press the SETUP button at any time.
To erase all loop data, press and hold the 5. LOOP STORE button again for
two more seconds. The DISPLAY will show Bu indicating the card is
being erased.
Erase All Loops - Memory Card
NOTE: If when you try to delete a loop from
SD card the display flashes CP, the SD copy
protection switch is in the “Locked” position.
To Next Page
Loading...
Need help?
General
