60
The JamMan
®
Delay has 99 memory locations and at some time you may need
to delete the contents of a memory location so it may be reused or to free up
memory. To delete a loop from a memory location, follow these steps:
Select the phrase you want to delete using the 1. LOOP SELECT buttons.
If the CARD MEM LED is lit, you have selected a loop on the optional
memory card.
Press and hold the 2. LOOP STORE button for 2 seconds until the DISPLAY
shows EL and release. The LOOP STORE button will begin flashing
waiting for a delete confirmation.
NOTE: If the DISPLAY shows Ei or EC, you have held the LOOP STORE
button too long and need to abort this procedure and start over.
Press the SETUP button at this point to abort the Delete procedure.
Press the 3. LOOP STORE button again. The display reads E? (Erase
Loop?). The LOOP STORE button will continue to flash. To abort this
procedure at any time, press the SETUP button at any time.
If you want to delete the contents from this memory location and 4.
return it to its default state, press and hold the LOOP STORE button
for two seconds. The DISPLAY will briefly read dE when the delete
procedure is complete and then return to the memory number.
Warning: Deleting a memory location is irreversible and will
erase any recorded information that resides here. Use the Delete
function with caution.
Deleting Individual Loop Phrases
To Next Page
Loading...
Need help?
General
