DigiTech JAMMAN - Loop; Single Phrases

54
Any phrase recorded into the JamMan
®
Delay can be played in two ways:
Either as a continuous Loop, or as a Single “one-shot” sample.
Single phrases are designed to play the recorded phrase only once and stop.
All phrases are recorded as loops by default but they can be changed to a
Single phrase if desired. You can always change Single phrases back to Loops
later without harming the phrase. To change between Single and Loop, follow
these steps:
Select a previously recorded Loop phrase (1. LOOP LED is lit) using the
LOOP UP/LOOP DOWN footswitches or SELECT buttons. If the CARD MEM LED
is lit, you have selected a memory location on the optional memory
card.
Press the2. SETUP button once. The LOOP or SINGLE LED will now be lit,
and th e DISPLAY will show Lo (loop) or Si (single).
Use the 3. SELECT buttons to select LOOP or SINGLE.
The 4. LOOP STORE button will light to indicate this change must be stored if
it is to be recalled later. Press the LOOP STORE button twice to store the
changes, if desired, or press the SETUP button four times to exit Setup
mode.
Single phrases cannot have overdubs added to them. Repeated presses of
the REC/PLAY/OVERDUB footswitch will just restart the Single phrase playback
from the beginning.
Loop / Single Phrases