34
Using an expression pedal with the JamMan
®
Delay is an easy way to unlock
a whole new set of time-varying delay effects. An expression pedal lets you
morph between different settings for a given delay type, allowing control
over Delay Level, Repeats, Time, and the Modify 1/2 settings.
To use an expression pedal with the JamMan Delay’s delay, follow these steps:
Begin with the JamMan Delay power disconnected.1.
Plug your expression pedal’s mono Tip/Sleeve 1/4” connector into the 2.
EXPRESSION PEDAL input on the back panel and apply power.
Set the 3. EXPRESSION ASSIGN switch to the In position (Delay).
Rock the expression pedal back and forth 2-3 times to calibrate the 4.
pedal with the JamMan Delay.
Rock the pedal forward to the toe down position.5.
Adjust one or more of the 6. DELAY LEVEL, TIME, REPEATS, MODIFY 1, MODIFY 2
knobs, and the MULTIPLIER setting to get the sound that you like.
Rock the expression pedal back to the toe up position. 7.
Adjust the delay controls again to get a starting sound that you like. 8.
NOTE: You cannot change delay types while using this expression pedal.
Changing types will reset the toe and heel settings.
Move the pedal from the heel to the toe position while you’re playing 9.
and listen to the delay morph between these two settings.
Store your changes to a delay footswitch.10.
When you store your changes to a footswitch, both the heel and toe settings
are stored. If you don’t have an expression pedal connected when that
footswitch is selected, you’ll hear the last stored settings.
To set the same settings for the heel and toe positions, follow these steps:
Rock the pedal to the toe down position.1.
Adjust the delay controls and multiplier to the desired settings.2.
Press and hold the 3. MULTIPLIER button until the selected multiplier LED flashes.
Now both the heel and toe positions will have the same settings.
Using an Expression Pedal - Delay
To Next Page
Loading...
Need help?
General
