DigiTech JAMMAN User Manual

46
Anytime a change is made to a loop memory location (Rhythm Type, Tempo,
Time Signature, Record, Overdubs etc.) the LOOP STORE button will immediately
light. This indicates that the changes will be lost unless a store procedure is
performed before selecting a new loop memory location, turning off the power.
Store Changes to a Loop
Stop any recording activity using the 1. TEMPO/STOP footswitch.
Press the 2. LOOP STORE button. The LOOP STORE button and the DISPLAY
will begin to flash (the DISPLAY shows the current loop memory
location).
(Optional) Use the 3. SELECT buttons to select an empty loop memory
location to store the loop with its changes (the LOOP or SINGLE LEDs
are off), or press SETUP to abort.
Press the 4. LOOP STORE button again. The changes are now saved and
the LOOP STORE button turns off.
Copy a Loop to a Different Memory Location
Stop any playback or record activity using the 1. TEMPO/STOP footswitch.
Use the 2. SELECT buttons to select a memory location that contains a
loop (either the LOOP or SINGLE LED is lit).
Press the 3. LOOP STORE button. The DISPLAY and the LOOP STORE button
will begin to flash.
Use the 4. SELECT buttons until an empty memory location is selected
(the LOOP and SINGLE LEDs are off), or press SETUP to abort.
Press the 5. LOOP STORE button again. The loop is now copied to the
new memory location.
Note: The Clear and Overdub Undo/Redo functions cannot be performed
to the loop after a Store/Copy procedure.
Storing/Copying Phrases

DigiTech JAMMAN Specifications

General

Technology	Digital
MIDI	No
Type	Looper
Memory	Internal memory for loop storage
Power Supply	9V DC
Outputs	1 x 1/4" Mono