58
You can also use an expression pedal to control the Looper’s level during
performance. To do this, follow these steps:
Begin with the 1. JamMan
®
Delay power disconnected.
Plug your expression pedal’s standard 1/4” connector into the 2.
EXPRESSION PEDAL input on the back panel and apply power.
Set the 3. EXPRESSION ASSIGN switch to the Out position (Looper).
Rock the expression pedal back and forth 2-3 times to calibrate the 4.
pedal with the JamMan Delay.
Start playback of the looper by pressing the 5. REC/PLAY/OVERDUB
footswitch.
Adjust the 6. LOOP LEVEL knob to the maximum output level you want the
loop to playback at.
Rock the expression pedal forward (toe down) and back (toe up) at 7.
least 2 times.
The expression pedal is now calibrated to give you the maximum level set
by the LOOP LEVEL knob in the toe down position and silence in the toe up
position. This way you can add overdubs to your loops and bring back the
mix back a bit during performance as needed.
Using an Expression Pedal - Looper
To Next Page
Loading...
Need help?
General
