Digitus DN-95301 - Logging on to the Switch; Web-Based Configuration; Logging on the Switch; Command Line Interface (by Console or Telnet)

Flow Control: None
1.5.3.Logging on to the switch
Enter the factory default user name “admin” with no password when logging
on to the switch. The password is set to be empty. If you can enter “?” on the
command line screen, it will display all items so that you can configure by your
requirements.
1.6.Web-based configuration
The Switch provides a Web-based interface for configuring and managing the
Switch. This interface allows you to access the switch using the Web browser
of your choice. This chapter describes how to use the switch’s Web browser
interface to con-figure and manage the switch.
1.6.1.Logging on the switch
To log on to the Switch:
1. In your web browser, specify the IP address of the switch. Default IP
address is 192.168.1.254.
2. Enter the factory default “admin “to login on the Switch with no password.
Refer to the figure 3-1.
Figure 3-1
1.7.Command Line Interface (by Console or Telnet)
1.7.1.Mode-based Command Hierarchy
The Command Line Interface (CLI) groups all the commands in appropriate
modes by the nature of the commands. Examples of the CLI command modes
are described below. Each of the command modes supports specific switch’s
Layer 2/2+ Management Switch Series 11