Digitus DN-95301 - Radius-Server

Mode Global Config
9) lldp mgmt-addrtxport
A range of ports can be set.
Format lldp mgmt-addrtxport ports <port list>
Mode Global Config
e.g. switch(config)# lldp mgmt-addrtxport ports 1
switch(config)# lldp mgmt-addrtxport ports 1-4
log
This command is used to configure log server
1) log log-server
This command is used to configure log server
1.1) log log-server name <WORD>add
This command is used to specify log server name, enter a name, up to
12 characters, add a log server IP address
Format log log-server name <WORD> add ipaddr word
Mode Global Config
1.2) log log-server name <word> delete
This command is used to delete a log server
Format log log-server name <WORD> delete
Mode Global Config
2) log logging-target
This command is used to configure log notification level
2.1) log logging-target memory
This command is used to specify memory log notify-level
Format log logging-target memory {enable|disable}
Mode Global Config
2.2) log logging-target flash
This command is used to specify flash log notify-level
Format log logging-target flash {enable|disable}
Mode Privileged Mode
2.3) log logging-target console
This command is used to specify console log notify-level
Format log logging-target console {enable|disable}
Mode Global Config
2.4) log logging-target server
This command is used to specify console log notify-level
Format log logging-target server name <WORD> {enable|disable}
Mode Global Config
radius-server
This command is used to configure radius server
Format radius-server ip <IP addr>
Mode Global Config
static-address
This command is used to specify static address
1) static-address add
This command is used to add static mac address
Format static-address add <mac addr> vid <vlan-ID> port <port-ID>
Mode Global Config
Layer 2/2+ Management Switch Series 25