4.1) vlan port all
This command is used to configure all ports
1.1) vlan port all port-configure
This command is used to configure ports in a specific vlan
Format vlan port all port configure <vlan-ID>
Mode Global Config
1.2) vlan port all protected
This command is used to configure protected ports
Format vlan port all protected {enable|disable}
Mode Global Config
1.3) vlan port all pvid
This command is used to configure port pvid
Format vlan port all pvid <vlan-ID>
Mode Global Config
4.2) vlan port ports
This command is used to configure multiple ports
4.2.1) vlan port ports port-configure
This command is used to configure ports in a specific vlan
Format vlan port ports port-configure <vlan-ID>
Mode Global Config
4.2.2) vlan port ports protected
This command is used to configure protected ports
Format vlan port ports protected {enable|disable}
Mode Global Config
4.2.3) vlan port ports pvid
This command is used to configure port vid
Format vlan port ports pvid < vlan-ID>
Mode Global Config
5) vlan lag
This command is used to configure lag to a special vlan
5.1) vlan lag vlan < vlan-id> exclude
This command is used to remove lag from a vlan
Format vlan lag vlan < vlan-ID> exclude lags <lag-ID>
Mode Global Config
5.2) vlan lag vlan <vlan-ID> untagged
This command is used to set to untagged lag.
Format vlan lag vlan <vlan-ID> untagged lags <lag-ID>
Mode Global Config
5.3) vlan lag vlan <vlan-ID> tagged
This command is used to set to tagged lag.
Format vlan lag vlan <vlan-ID> tagged lags <lag-ID>
Mode Global Config
bridge
This command is used to configure switch aging time
Format bridge aging-time <0-1048575>
Mode Global Config
lacp-syspri
This command is used to configure lacp system priority
Format lacp-syspri system-priority <0-65535>
Layer 2/2+ Management Switch Series 23
To Next Page
Loading...
