full/ 1000Mbps 100FX mode/1000base-x full .
Format speed {10hd | 10fd | 100hd | 100fd | 1000fd | 100fx | 1000base-x}
Mode Interface Config
flow-control
This command enable/disable flow-control at port.
Format flow-control {enable | disable}
Mode Interface Config
port-security
1) port-security
This command add or delete a static mac into mac security table.
Format port-security {add|delete} <sourcemac >
Mode Interface Config
2) port-security lock-mode
This command disable port security or specify static lock mode.
Format port-security lock-mode {none | static}
Mode Interface Config
3) port-security lock-mode dynamic
This command enable limited dynamic lock mode,and specify maximin
learning entries for limited dynamic lock mode.the max-entries value :0~24
Format port-security lock-mode dynamic max-entries 24
Mode Interface Config
qos
This command specifies port-based qos.
Format qos port-based status {enable | disable}
Mode Interface Config
rate-limit
1) rate-limit egress
This command limits egress rate, which the unit is Kbps.
Format rate-limit egress <rate>
Mode Interface Config
2) rate-limit ingress
This command limits ingress rate, which the unit is Kbps.
Format rate-limit ingress <rate>
Mode Interface Config
storm-control
1) Enable/disable storm control.
Format storm-control {enable | disable}
Mode Interface Config
2) storm-control broadcast
This command storm control for broadcast only, and limited value :
0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps and 0
means no limit.
Format storm-control broadcast <rate>
Mode Interface Config
3) storm-control broadcast-multicast
Layer 2/2+ Management Switch Series 43
To Next Page
Loading...
