Mode Global Config
link-aggregation
This command is used to configure link aggregation
1) link-aggregation addport
This command is used to configure LAG groups
Format Link Aggregation addport lag <LAG-ID>
Mode Global Config
2) link aggregation delport
This command remove ports from LAG
2.1) Link Aggregation delport all
This command remove all ports from a LAG
Format link-aggregation-delport all lag <LAG-ID>
Mode Global Config
2.2) link aggregation delport lag
This command remove specify LAG group
Format link aggregation delport lag <LAG-ID>
Mode Global Config
lldp
1) lldp enable
This command is used to enable lldp functions
Format lldp enable
Mode Global Config
2) lldp disable
This command is used to disable lldp functions
Format lldp disable
Mode Global Config
3) lldp adv-interval
This command is used to specify advertised interval in seconds
Format lldp adv-interval <5-32768>
Mode Global Config
4) lldp fast-startcnt
This command is used to specify fast-start count
Format lldp fast-startcnt <1-10>
Mode Global Config
5) lldp hold
This command is used to specify hold value
Format lldp hold <2-10>
Mode Global Config
6) lldp notify-interval
This command is used to specify notification interval in seconds
Format lldp notify-interval <5-3600>
Mode Global Config
7) lldp reinit-delay
This command is used to specify re-initialization delay in seconds
Format lldp reinit-delay <1-10>
Mode Global Config
8) lldp tx-delay
Transmit Delay in seconds
Format lldp tx-delay <1-8192>
Layer 2/2+ Management Switch Series 24
To Next Page
Loading...
