This command configure the path cost on a MST instance :
1~200000000.
Format spanning-tree mst cost <pathcost>
Mode Interface Config
5.2) spanning-tree mst priority
This command configure the port priority on a MST instance:0~4096.
Format spanning-tree mst priority <1 4096>
Mode Interface Config
6) spanning-tree participation
This command configures RSTP capability on a port.
Format spanning-tree participation {enable|disable}
Mode Interface Config
7) spanning-tree priority
this command configure RSTP port priority:0~240
format spanning-tree priority <0..240>
mode Interface Config
vlan
1) vlan participation
This command join or leave a port to a vlan.
1.1) vlan participation exclude
This command leave a vlan.
Format vlan participation exclude < vlan id>
Mode Interface Config
1.2) vlan participation
This command join a vlan with untagged/tagged mode.
Format vlan participation {untagged |tagged}< vlan id>
Mode Interface Config
2) vlan protected
This command configures port protected property.
Format vlan protected {enable|disable}
Mode Interface Config
3) vlan dropnq
This command configure port drop none 802.1Q frame .
Format vlan dropnq {enable|disable}
Mode Interface Config
4) vlan pvid
This command configure port PVID.
Format vlan pvid <pvid>
Mode Interface Config
e.g. Switch(Interface 1)# vlan pvid 1
Interface commands
This command change another interface
Format Interface <port number>
Mode Interface Config
e.g. Switch(Interface 1)# interface g1
poe
1) func
Layer 2/2+ Management Switch Series 45