Digitus DN-95301 - Green-Eth

Mode Global Config
green-eth
Note: This command only supports on the following switches,
4. 24-Port 1000BaseT with 2 shared Gigabit SFP Layer 2+ Management Switch
5. 48-Port 1000BaseT with 4 shared Gigabit SFP Layer 2+ Management Switch.
This command is used to enable/disable green Ethernet function. Enable
green Ethernet mode will reduce system power consumption when the link is
not present.
Format green-eth { enable | disable }
Mode Global Config
1.7.5.Interface Config mode commands
exit
Exit current shell
Format exit
Mode Interface Config
dot1x
Set 802.1x port control.
Set auto-authorized on ports
Format 802.1x port-control {enable|disable}
Mode Interface Config
lacp
1) admin command
Configure admin key of port
Format lacp admin <0 ..65535>
Mode Interface Config
e.g. switch(interface g1)#lacp admin 36768
2) priority command
Configure lacp port priority
Format lacp priority <0..65535>
Mode Interface Config
addport
add one port to a LAG group
Format addport <LAG-ID>
Mode Interface Config
delport
Remove a port from a LAG group
Format delport <LAG-ID>
Mode Interface Config
lldp
An lldp agent can transmit information about the capabilities and current
status of the system associated with its MSAP identifier. The lldp agent can
Layer 2/2+ Management Switch Series 41