Digitus DN-95301 - Admin-Mode

also receive information about the capabilities and current status of the
system associated with a remote MSAP identifier. However, lldp agents are
not provided any means of soliciting information from other lldp agents via this
protocol.
1) lldp state set
Only transmit the lldp status
Format lldp state {tx | rx | tx_rx | disable}
Mode Interface Config
2) configure notifications
Enable/disable notification form the agent
Format lldp notification {enable|disable}
Mode Interface Config
3) Configure med notifications
Configure whether or not MED notifications from the agent are enabled.
Enable/disable med notification form the agent
Format lldp med-notification {enable | disable}
Mode Interface Config
e.g. Switch(Interface 1)#lldp med-notification enable
4) Configures which TLVs are enabled for transmission.
4.1) basic set
Format lldp tlvs-tx {enable | disable} option basic {port-desc | sys-name
| sys-desc | sys-capa | sys-capa }
Mode Interface Config
4.2) 8021 set
Status of local-802.1 settings
Format lldp tlvs-tx {enable | disable} option 8021 {pvid | vlanname |
protocol-id}
Mode Interface Config
eg.switch(interdface 1)lldp tlvs enable option 8021 pvid
4.3) 8023 set
Format lldp tlvs-tx {enable | disable} option 8023 {mac-phy | power|
link-aggregation| frame-size}
Mode Interface Config
4.4) MED-set
Status of MED Settings
Format lldp tlvs-tx {enable | disable} option med-set {capabilities | net-
policy | location-id | mdi}
Mode Interface Config
admin-mode
Configure administrative mode on a port
Format Switch(Interface 1)# admin-mode {enable | disable}
Mode Interface Config
auto-negotiate
Configure auto-negotiate mode on a port
Format auto-negotiate {enable | disable}
Mode Interface Config
speed
Set port speed to 10Mbps half duplex/ 10Mbps full/ 100Mbps half/ 100Mbps
Layer 2/2+ Management Switch Series 42