Digitus DN-95301 - Spanning-Tree

spanning-tree
1) spanning-tree forceversion
This command configures Spanning Tree protocol version.
1.1) spanning-tree forceversion 8021s
This command selects spanning tree type as 8021.s(multiple Spanning
Tree).
Format spanning-tree forceversion 8021s
Mode Global Config
1.2) spanning-tree forceversion 8021w
This command selects spanning tree type as 802.1w(rapid Spanning
Tree).
Format spanning-tree forceversion 8021w
Mode Global Config
1.3) spanning-tree forceversion none
This command selects none spanning tree type.
Format spanning-tree forceversion none
Mode Global Config
2) spanning-tree configuration
This command configures MSTP region name and revision.
2.1) spanning-tree configuration name
This command configures MSTP region name (Max.32 chars).
Format spanning-tree configuration name <WORD>
Mode Global Config
2.2) spanning-tree configuration revision
This command configures revision level.
Format spanning-trees configuration revision <0-65535>
Mode Global Config
3) spanning-tree forward-time
This configures the bridge forward delay parameter.
Format spanning-tree forward-time <4-30>
Mode Global Config
4) spanning-tree max-age
This command configures the bridge max age parameter.
Format spanning-tree max-age <6-40>
Mode Global Config
5) spanning-tree max-hops
This command configure the number of hops in a region.
Format spanning-tree max-hops <1-40>
Mode Global Config
6) spanning-tree port
6.1) spanning-tree port all
This command specifies RSTP capability for all ports.
Format spanning-tree port all {enable |disable}
Mode Global Config
6.2) spanning-tree port cost
This command configures RSTP port path cost.
Format spanning-tree port cost <0-200000000>
Mode Global Config
6.3) spanning-tree port priority
This command configures RSTP port priority.
Layer 2/2+ Management Switch Series 34