EasyManua.ls Logo

Digitus DN-95301 - Page 35

Digitus DN-95301
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Format spanning-tree port priority <0-24>
Mode Global Config
6.4) spanning-tree port edge
This command configures STP edge .
Format spanning-tree port edge {enable|disable}
Mode Global Config
6.5) spanning-tree port force-p2plink
This command configures force point to point link mode on ports.
Format spanning-tree port force-p2plink {auto|enable|disable}
Mode Global Config
6.6) spanning-tree port migration-check
This command Re-checks the appropriate BPDU format to send on
ports.
Format spanning-tree port migration-check {enable|disable}
Mode Global Config
7) spanning-tree priority
This command configures RSTP bridge priority value.
Format spanning-tree priority <0-61440>
Mode Global Config
8) spanning-tree mst
Configure a multiple spanning tree instance.
8.1) spanning-tree mst instance
This command creates or removes a MST instance
8.1.1) spanning-tree mst instance add
This command creates a MST instance.
Format spanning-tree mst instance add vlan <vlan list> mstpid <MST
ID>
Mode Global Config
e.g. Switch(Config)# Spanning-Tree mst instance add vlan 2-5 mstpid 2
Switch(Config)# Spanning-Tree mst instance add vlan 6 mstpid 3
8.1.2) spanning-tree mst instance delete
This command removes the last MST instance.
Format spanning-tree mst instance delete
Mode Global Config
8.2) spanning-tree mst vlan
This command adds or deletes vlan frome a MSTP instance.
8.2.1) spanning-tree mst vlan <MST ID> <vlan list> add
This command creates a MST instance.
Format spanning-tree mst vlan <MST ID> <vlan list> add
Mode Global Config
e.g. Switch(Config)# Spanning-Tree mst vlan 3 3-5 add
8.2.2) Spanning-Tree mst vlan <MST ID> <vlan list> delete
This command deletes a vlan from a MST instance.
Format Spanning-Tree mst vlan <MST ID> < vlan list> delete
Mode Global Config
8.3) spanning-tree mst bridgepri
This command configures bridge priority for a MST instance.
Format spanning-tree mst bridgepri <MST ID> <priority>
Mode Global Config
8.4) spanning-tree mst cost
This command configures port path cost in a MST instance.
Layer 2/2+ Management Switch Series 35

Other manuals for Digitus DN-95301

Related product manuals