This command enables global 802.1x function.
Format dot1x enable
Mode Global Config
2) dot1x disable
This command disables global 802.1x function.
Format dot1x disable
Mode Global Config
3) dot1x port-control
Configure port auto-authentication mode.
3.1) dot1x port-control enable
This command set auto-authorized on a list of ports.
Format dot1x port-control enable port <port list>
Mode Global Config
3.2) dot1x port-control disable
This command set force authorized on a list of ports.
Format dot1x port-control disable port <port list>
Mode Global Config
e.g. Switch(config)# dot1x port-control disable port 1-4
network
1) network mgmt-vlan
This command changes management vlan.
Format network mgmt-vlan <vlan-ID>
Mode Global Config
2) network parms
This command configures static IP address of the switch.
Format network parms <IP addr> <subnet mask> <gateway>
Mode Global Config
3) network protocol
This command configure switch dhcp client.
Format network protocol {dhcp|none}
Mode Global Config
4) network dhcp-relay
Configure switch dhcp relay functions.
4.1) network dhcp-relay mode
This command configures dhcp relay mode.
Format network dhcp-relay mode {enable|disable}
Mode Global Config
4.2) network dhcp-relay server
This command configures dhcp-relay server ip-address.
Format network dhcp-relay server <A.B.C.D>
Mode Global Config
4.3) network dhcp-relay vlan
Configure dhcp-relay option-82 vlan information.
3.1) network dhcp-relay vlan <vlan-ID> add
This command enters a vlan which will be enable DHCP-relay option82.
Format network dhcp-relay vlan <vlan-ID> add
Mode Global Config
3.2) network dhcp-relay vlan <vlan-ID> remove
This command enters a vlan which will be disable dhcp-relay option82.
Format network dhcp-relay vlan <vlan-ID> remove
Layer 2/2+ Management Switch Series 27
To Next Page
Loading...
