Digitus DN-95301 - Port-All

Mode Global Config
5) network sysinfo
Configure switch system information.
5.1) Network sysinfo sysname
This command configures system name.
Format network sysinfo sysname <WORD>
Mode Global Config
5.2) network sysinfo syslocate
This command configures system location.
Format network sysinfo syslocate <WORD>
Mode Global Config
5.3) network sysinfo syscontact
This command configures system contact information.
Format network sysinfo syscontact <WORD>
Mode Global Config
6) network admin-timeout
This command configures web/console admin time out interval.
‘0’ means disable.
Format network admin-timeout <0-65535>
Mode Global Config
port-all
1) port-all admin-mode
This command configures ports admin mode.
Format port-all admin-mode {enable | disable}
Mode Global Config
2) port-all auto-negotiate
This command configures ports auto-negotiation mode.
Format port-all auto-negotiate {enable|disable}
Mode Global Config
3) port-all flow-control
This command configures ports flow control.
Format port-all flow-control {enable|disable}
Mode Global Config
4) port-all portsec-lockmode
Configure port security.
4.1) port-all portsec-lockmode none
This command disable port security.
Format port-all portsec-lockmode none
Mode Global Config
4.2) port-all portsec-lockmode static
Note: This commands only support on 24-Port 100BaseTX + 2 Gigabit
combo Layer 2 Management Switch & 48-Port 100BaseTX + 4 1000BaseT with 2
shared Gigabit SFP Layer 2+ Management Switch models
This command enable static lock mode.
Format port-all portsec-lockmode static
Mode Global Config
4.3) port-all portsec-lockmode dynamic
This command enable limited dynamic lock mode.
Format port-all portsec-lockmode dynamic max-entries <0-24>
Mode Global Config
Layer 2/2+ Management Switch Series 28