Digitus DN-95301 - Page 29

5) port-all rate-limit
Configure rate limit value on all ports.
5.1) port-all rate-limit egress
This command specifies egress rate limit.
Format port-all Rate-Limit egress <value>
Mode Global Config
5.2) port-all rate-limit ingress
This command specifies ingress rate limit.
Format port-all rate-limit ingress <value>
Mode Global Config
6) port-all rmon-counter
This command configures rmon counter capability on ports.
Format port-all rmon-counter {enable|disable}
Mode Global Config
7) port-all speed
This command configures ports speed.
Format port-all speed {10hd|10fd|100hd|100fd}
Mode Global Config
8) port-all storm-control
Configure all ports’ storm control settings.
8.1) port-all storm-control disable
This command disables storm control.
Format port-all Storm-Control disable
Mode Global Config
8.2) port-all storm-control broadcast
This command configures storm control for broadcast only.
Format port-all storm-control broadcast <value>
Mode Global Config
8.3) port-all storm-control broadcast-multicast
This command configures storm control for broadcast and multicast.
Format port-all Storm-Control broadcast-multicast <value>
Mode Global Config
8.4) port-all storm-control broadcast-unknown
This command configures storm control for broadcast and unknown
unicast.
Format port-all storm-control broadcast-unknown <value>
Mode Global Config
8.5) port-all storm-control all-cast
This command configures storm control for broadcast, multicast and
unknown unicast.
Format port-all Storm-Control all-cast <value>
Mode Global Config
qos
1) qos qos-advanced
Configure qos advanced mode.
1.1) qos qos-advanced DSCP
This command enables DSCP mode.
Format qos qos-advanced DSCP
Mode Global Config
1.2) qos qos-advanced ip_precedence
Layer 2/2+ Management Switch Series 29